Thread: Rail Damage
View Single Post
Old 05-23-2020, 09:31 AM   #5
Floivanus
Senior Member
 
AKaholic #: 191191
Join Date: Jan 2017
Location: Northern IN
Posts: 845
Default

Quote:
Originally Posted by ServiceRifle View Post
I think its really clear. You need to drill out those welds on that rail - remove it - fill in the holes - buy yourself a replacement rail - reweld it onto the receiver - refinish the receiver, and then sit back with a beer and a smoke comfortable in the knowledge that you prevented a major cosmetic disaster from happening.

P.S. I've been called an a..hole by better people than you!
Yeah, if it was a stamped gun, OP has to do the right thing, cut it in half, itís never going to be right again.

That ding in the ejector? Itís fine, if the bolt cycles, G2G, if not buy a file and make it cycle.
Floivanus is offline   Reply With Quote