05-25-2009, 09:43 PM
|
#1 |
|
Member
AKaholic #: 8626 Join Date: Jul 2007
Posts: 102
|
NoDak Spud receivers....
I building on a NoDak Spud for the first time. It claims "fully heat treated". Does that mean I don't have to heat treat the ejector or firing group holes?
|
|
|
|
05-25-2009, 10:11 PM
|
#2 |
|
Veteran Member
AKaholic #: 8980 Join Date: Aug 2007
Posts: 1,749
|
Yep.
__________________
The beauty of the Second Amendment is that it will not be needed until they try to take it. - Thomas Jefferson They say that liberals are elite, but you're a liberal and you're just another moron. - Bucky Katt I'm disgruntled and I have a gun, Is the Post Office hiring? |
|
|
|
|
05-25-2009, 10:17 PM
|
#3 | |
|
Devil's Advocate
AKaholic #: 5678 Join Date: Apr 2006
Location: Houston, Texas
Posts: 13,262
|
Quote:
Heat treating is only done when you bend your own flat. |
|
|
|
|
05-26-2009, 04:43 PM
|
#4 |
|
Member
AKaholic #: 5421 Join Date: Feb 2006
Location: Florida
Posts: 444
|
Nodak has the best quality IMO. I had an Ohio Rapid Fire receiver a few months back and they heat treated the areas with a torch.
It looked a tapco flat job with a stamp. Anyhow, what they said. DCI are good to go out of the box. Last edited by akDave; 05-26-2009 at 06:42 PM. |
|
|
|
|
05-26-2009, 06:29 PM
|
#5 |
|
Member
AKaholic #: 8626 Join Date: Jul 2007
Posts: 102
|
Yeah, they are sweet. I built my first three on bent flats. I made a lot of mistakes, smashed a lot of ugly rivets before getting things right.
I rebuilt one gun... my first... because it wasn't cycling quite right. This one came out perfect. All rivets came out perfect! The other two are not quite perfect, but I am the only one who notices the imperfections. Now I am ready to blast and park all three. |
|
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
