View Single Post
Old 11-05-2007, 02:59 PM   #19
dstorm1911
Curio & Relic
 
dstorm1911's Avatar
 
AKaholic #: 4307
Join Date: Aug 2005
Location: Mostly Tucson, AZ
Posts: 2,758
Default

when ya re-drill ya just need to go large enough to give a clean hole the trunion will require a good bit and lots of oil but the barrel is soft and will go very fast then the other side of the trunion will be back to taking your time and again lots of oil, I've dealt with some that required as much as .020" oversize pins ya will need to see how far off your barrel cut is, if ya can measure the bottom of the cut in the barrel it will give ya an idea how much oversize ya will need to go...
dstorm1911 is offline   Reply With Quote