View Single Post
Old 11-04-2007, 01:25 PM   #15
Random Chaos
Member
 
AKaholic #: 1747
Join Date: Feb 2004
Location: GA
Posts: 66
Default

Quote:
Originally Posted by dstorm1911

An over sized pin journal will cause the same effect instead of actually removing the barrel try resettting the headspace so it will barelly close on a go gauge then drill out to a larger barrel pin diameter this will avoid disturbing the set the barrel has already made in the journal...
Thanks to all for the help, I am not a noobie at this but I do have another question, how much should I drill out the journal? I know renuzit can furnish oversize pins but what size bit should I use and what size pin should I go with. Also in doing the re-headspacing, is that a press a little and then test and repeat until it is right procedure?
Random Chaos is offline   Reply With Quote