View Full Version : Magpul MOE stock brass washer with PSAK-47

05-13-2017, 10:14 AM
Hello all,

I have the psak-47 gb2 and it looks like the included brass washer is not necessary.
I tried installing the Magpul MOE stock with brass washer and was unable to run the bolt over the screw. Without brass washer, the screw will fit into the bevel and allow bolt carrier to run over it without contact.
My question is this:
Will leaving out the brass washer create an unsafe condition?
Also, palmetto did not send me a grip screw with my build kit. That kinda sucked, having put everything together only to find I can't grip the gun, haha!

Thanks for any help you can provide, forum!