chipster
11-14-2007, 12:43 PM
Please let's not bring any drama to this thread!
I have a GALIL built on an early generation (32X) receiver by a competent gunsmith. However the gunsmith wasn't aware of some ammendments that needed to be made to the receiver for the best fit/function. As a result the bolt carrier is very tight in relation to the ejection port and is VERY difficult to manually open. I don't have the resources to do this work, make it look good and do the necessary refinishing. While this rifle is @ a gunsmith I would also like to have the 'fixes' necessary to enable the AR-15 mag adaptors to work with this rifle also done.
No Drama, No BS, nothing, all I need is real, actual contacts of folks who will still work on ORF receivers who are competent @ completing this work.
thanks for any leads!
I have a GALIL built on an early generation (32X) receiver by a competent gunsmith. However the gunsmith wasn't aware of some ammendments that needed to be made to the receiver for the best fit/function. As a result the bolt carrier is very tight in relation to the ejection port and is VERY difficult to manually open. I don't have the resources to do this work, make it look good and do the necessary refinishing. While this rifle is @ a gunsmith I would also like to have the 'fixes' necessary to enable the AR-15 mag adaptors to work with this rifle also done.
No Drama, No BS, nothing, all I need is real, actual contacts of folks who will still work on ORF receivers who are competent @ completing this work.
thanks for any leads!