need help with assem. POLISH UNDER

[38supercomp]

Can anyone give my detaied instuction on putting the trigger group together on a polish uderfolder kit on a Hesse rec.? This is my first build, first ak. I have three pins with trigger parts, and only two holes in my rec. I think I got the trigger, hammer and sear positions figued put put then there are two more springs, one small and one with a long leg on it. I'm assuming that's what retains the trig. and hammer pins. Then I also have the other two parts that I have no idea what they are or where they go. Want to shoot bad!! Please help!!! Thanks in advance.

[Packrat]

Send me your address, and I'll send you a pic of the layout. It's too big to post. postmatch2004@yahoo.com

[Rhino_66]

For instructions on removal and installation details, check out this one:

http://www.gunsnet.net/Linx310/fcgremoval.htm

EDIT: The disconnector shown on the first page is a full-auto piece and should NOT be installed in a semi-auto rifle. There is a possibility that the selector could engage the step in the tab on the back of the disconnector and lock it out while still allowing the trigger to move. This could lead to the hammer following the bolt closed on a live round, letting the rifle fire out of battery.

If you are able to use the import trigger group, you should grind off the stepped tab as shown on this page:

http://www.gunsnet.net/Linx310/slapfix.htm

If you have replaced your trigger group with a U.S. made set (I recommend the Tapco G2 group), the tab on the back of the disconnector will not be present.

What parts have you replaced to meet the 10 import parts limit?